Unlike a recessed fixture, this mounts on the surface — visible, specified as part of the wall’s look, not hidden inside it.
Why this collection?
Every aluminum housing in this collection begins as raw metal, not a finished shape.
Die-casting, step by step
Aluminum ingots (12# / ADC12-grade alloy) melted in a furnace
Molten aluminum is injected under high pressure into a hardened steel mold
The casting solidifies within seconds under continued pressure
Excess flash along the mold seams is removed
Mounting points and optic seats are CNC-machined to tolerance
Sanded, sealed, and powder-coated in the specified color
Custom-molded forms give outdoor lighting greater flexibility in shape, scale, and integration while maintaining the performance required for exterior environments.
Every fixture is tested before it leaves the facility — not sampled, not spot-checked.
Raw materials and components are checked before production.
Fixtures are checked at each production stage.
Every finished unit is inspected before it ships.
In-house lab testing
Confirms dust and water sealing meets its published rating, critical for a fixture recessed into the ground
Confirms housings and seals hold under rapid temperature swings
Simulates long-term outdoor exposure in temperature and humidity chambers
Confirms beam angle and output match spec
Verifies component strength and finish durability
Confirms wiring and insulation meet safety requirements
What sets us apart
Running the full process in-house — tooling, casting, machining, electronics, and finishing — rather than distributing it across outside subcontractors delivers three concrete advantages:
Machined flange, reamed bolt holes and a seated gasket — tolerance and finish quality visible in a single frame.
Cutting our own tooling in-house means no waiting on an outside toolmaker between order and first unit.
Hundreds of housings from one mold — dimensional repeatability is what holds a spec to the five-hundredth unit.
Compact square and round housings for standard floodlight and spotlight models
Elongated, linear profiles for wall washer models covering longer runs
Irregular, sculptural forms within Architectural Effects
Exact dimensions vary by model — confirm on the spec sheet
Analog dimming that works with most existing site controls, no retrofitting required.
Addressable, for projects running zoned commercial control.
Dims cleanly even at the lowest output levels, without visible flicker.
LED throughout the collection
Wattage typically ranges from 2.8 W to 75 W across all collection
CRI 80 as standard
Same hardware, different optic — that’s what changes the fixture’s role.
Wide, high-output, built for area coverage.
Narrow and directional, built to highlight a subject.
Wide, angled across a surface rather than outward.
No defined edge, an ambient glow.
Floodlight and spotlight models.
Wall washer models.
Soft light, for ambient comfort.
Architectural Effects.
IP65-rated throughout.
Choose your product and specify it your way.
Our team is here to help at every stage.